Filter By:
Indoor Cycling
$25.00
The Saris Leveling Block keeps your bike level with your trainer.
- Adds stability to your training ride.
- For use with any rear wheel-mounted trainer.
- Raises front bicycle tire 1.1 inches (2.8 cm) off the ground
$54.00
Our Trainer Axle is designed to adapt your thru-axle equipped bike to on-wheel trainers, such as a 1up, Blackburn, Cyclops, Kinetic, Tacx, Wahoo, and many others. Our goal is to fit the thru-axle to your bike perfectly to minimize spacers and extra parts, providing a clean, high-performance axle for your bike. Train, warm up, and be race ready and fit for the season.
- When it’s time for your race or time to head outside, simply remove your bike from the trainer, remove the drive side axle end and go. Our axle is suitable for use on or off the trainer, indoors or out.
- The axle shaft and axle ends are precision CNC-machined from 7075 aluminum and hard-anodized for rugged durability.
- No special tools required. Design allows for installation or wheel removal using your standard 5mm hex wrench.
- Designed, built, and quality tested in the USA. Proven around the world.
Important: Before you order, make sure your specific trainer will accommodate the width of your modern thru-axle-equipped bike. Measure your trainer at the widest setting and measure the outside width of your bike frame. Our the trainer axle ends will extend past your frame on each side.
$54.00
Our Trainer Axle is designed to adapt your Surly MDS/Gnot Boost thru-axle-equipped bike to on-wheel trainers, such as a 1up, Blackburn, Cyclops, Kinetic, Tacx, Wahoo, and many others. Our goal is to fit the thru-axle to your bike perfectly to minimize spacers and extra parts, providing a clean, high-performance axle for your bike. Train, warm up, and be race ready and fit for the season.
- This axle is for Surly bikes with the MDS/Gnot Boost system.
- When it’s time for your race or time to head outside, simply remove your bike from the trainer, remove the drive side axle end and go. Our axle is suitable for use on or off the trainer, indoors or out.
- The axle shaft and axle ends are precision CNC-machined from 7075 aluminum, and hard-anodized for rugged durability.
- No special tools required. Design allows for wheel installation or removal using your standard 5 mm hex wrench.
- Designed, built, and quality tested in the USA. Proven around the world.
$59.99
- Adapts a thru axel hub bike for a trainer.
- Only compatible with current classic series trainers.
- Fits most 142-148 Thru axle bikes with 1.0 or 1.75 thread pitch
- Kit consists of an axle, washers, end caps with bolts and a shorter version of our bolt action slider for the classic series trainer.
- The axle is threaded on both sides to fit Syntace and Maxle/ABP style thru axle systems.
Page 1 of 1